Procom PCD18T Guia de Instalação descarregar pdf (Página 20)

Figure 37– Incorrect Flame Pattern with

Control Knob Set to High Flame

More than 8” Above Top of Logs

Figure 34 – Correct Pilot Flame Pattern

Figure 35– Incorrect Pilot Flame Pattern

Figure 36– Correct Flame Pattern with

Control Knob Set to High Flame

More than 3-6” Above Top of Logs

INSPECTING BURNERS

Check pilot ame pattern and burner ame patterns often.

PILOT FLAME PATTERN

Figure 34 shows a correct pilot ame pattern. Figure 35 shows an incorrect pilot ame pattern. The incorrect pilot

ame is not touching the thermocouple. This will cause he thermocouple to cool. When the thermocouple cools,

the heater will shut down.

If pilot ame pattern is incorrect, as shown in Figure 35:

• Turn heater off (see “To Turn Off Gas To Appliance”).

• See Troubleshooting, page 22.

BURNER FLAME PATTERN

Figure 36 shows a correct burner ame pattern. Figure 37 shows an incorrect burner ame pattern. If burner

ame is incorrect:

• Turn heater off.

• See Troubleshooting, page 22.

BURNER PRIMARY AIR HOLES

Air is drawn into the burner through the holes in the fitting at the entrance to the burner. These holes may

become blocked with dust or lint. Periodically inspect these holes for any blockage and clean as necessary.

Blocked air holes will create soot.

BATTERY INSTRUCTIONS

• Batteries are included.

• Remove batteries when depleted.

• Install/replace the batteries according to the type and quantity stated in table below.

• Do not mix old and new batteries. New batteries should be the same brand for best results.

• Be sure to observe proper polarity (+/-) when installing or replacing the batteries. Damage due to improper battery

installation may void the warranty on the product.

• For remote control systems, maximize battery life by turning off the receiver when it is not in use.

• For long periods of non-operation, remove batteries from all components for safety.

Component Type of Battery Battery Qty.

Ignitor AAA 1

Remote Control AAA 2 or 3*

Remote Receiver AA 4

*Note: Quantity depends on model of remote control.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 29 30

Sem comentários

Procom PCD18T Guia de Instalação Página 20