Procom RD-C Manual do Utilizador descarregar pdf (Página 7)

Page 7 of 12

PWR

This indicator is located above the J1 (TERM) connector. When illuminated

with a steady red light, the PWR LED indicates that power is being applied

to the unit and the internal circuitry is operating properly. If

communication between internal components is lost the ProComm will

disable all outputs and the PWR LED will blink.

RUN

This indicator is located above the J1 (TERM) connector. When illuminated

with a steady red light, the RUN LED indicates normal program operation.

When communication is present from a transmitter using the proper

channel, the RUN LED will blink.

This indicator is located above the J2 (INPUT) connector. When illuminated

with a steady red light, the A LED indicates an input of 120VAC nominal

applied between J2-1 and J2-2.

This indicator is located above the J2 (INPUT) connector. When illuminated

with a steady red light, the B LED indicates an input of 120VAC nominal

applied between J2-3 and J2-4.

1-8

This set of indicators is located above the J3 (OUTPUT) connector. When

illuminated with a steady red light, each LED indicates an active coil on the

corresponding relay. Actual relay output state depends on n/o or n/c

configuration.

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Procom RD-C Manual do Utilizador Página 7